2020 Salsco, Inc. Engine Driven, Hydraulic Feed Chippers 813

Information

2020 Salsco, Inc. Engine Driven, Hydraulic Feed Chippers 813

Model 813 is a single feed roll unit with an extra wide 18" opening. Performance and durability is the trademark of this unit. Drain plugs on all tanks, fenders with light enclosures, 360º exhaust chute, lockable tanks and a full lockable engine enclosure, are just some of the standard features of this unit. All the basic components are included in base unit. Engine options include both gas and diesel engine packages.

Model 813 is built with the operator in mind, and will perform consistently and efficiently day after day.

Photos

Highlights

  • Eldersburg, Maryland
  • 2020
  • Salsco, Inc.
  • Engine Driven, Hydraulic Feed Chippers 813
  • Hatz | Kubota
  • Fenders: Extra heavy duty 1/4” thick diamond plate fenders with safety light guards.
  • Available
  • 7’ | Infeed Tray: 57”
  • 8’ | Infeed Tray: 33””

Specifications

  • 2020
  • Salsco, Inc.
  • Engine Driven, Hydraulic Feed Chippers
  • 813
  • Brush
  • Hatz | Kubota
  • Tier IV
  • 74HP | 74.3HP
  • Single plate or double plate over-center clutch depending on horse power for diesel engine options. Autoclutch on PSI gas engines.
  • Hoses: SAE JIC hose ends & fittings. 3,000 P.S.I. working, 12,000 P.S.I. burst. | Motors: One (1) Eaton Char-Lynn, Series H, 14.1 Cu.In.Disp
  • One (1) Eaton Gear pump, 5/8” 9-tooth spline shaft, 66 Cu.In.Disp.
  • 12 v., automotive type, 900 cold cranks. Lockable battery box.
  • Fenders: Extra heavy duty 1/4” thick diamond plate fenders with safety light guards.
  • 3/8” thick steel diamond plate fenders with light enclosures and flag holders
  • Adjustable height
  • Infeed Opening: Opening at feed roll, 13” high x 18” wide to accept 13” round wood. | Impeller Housing: Upper, lower, front & rear side housing is 3/8” steel plate. Housings are hinged & held in place by a 13” long x 3/4” diameter pin. Impeller inspection door. Upper housing is vented to provide more air flow for chip exhaust.
  • Exhaust Chute: 360º rotation, fixed height exhaust chute with adjustable chip deflector. No tools necessary to adjust.
  • 2-5/16” ball or 3” pintle
  • 17’ 6”
  • 7’ | Infeed Tray: 57”
  • 8’ | Infeed Tray: 33””
  • 24 gallon steel
  • 16-3/4 gallon steel tank, drain plug, lockable, vented, screw cap with dipstick.
  • 7,000 lb. Torflex | 8,000 lb. Torflex
  • 7,500 lbs. (Approximately)
  • Jack: Side wind swivel snap ring mount. 2,000 lb. lift
  • 4-bolt, heavy duty, cast iron, greaseable & self-centering