2020 Salsco, Inc. Engine Driven, Hydraulic Feed Chippers 86 Series

Information

2020 Salsco, Inc. Engine Driven, Hydraulic Feed Chippers 86 Series

The 86 Series Chippers are available with either a 25HP Gas, Kohler or a 37HP Gas E.F.I. Briggs & Stratton engine. These units can easily handle any 6" diameter branch with limbs. No need to do all that pruning; the infeed is 12" wide x 6" high. The 360º exhaust chute and the chip deflector are easily adjusted and no tools are necessary. These units have double bed knives, one vertical and one horizontal. Evergreens, palm fronds and vines are easily chipped and will not wrap around the impeller shaft as long as the bed knives are properly adjusted.

The 200 lb. fully balanced impeller is 1" thick x 26" in diameterwith 6 gusseted fan blades to expedite processed material. Extra wide knife pockets and a vented impeller housing increases air flow, greatly improving exhaust of chipped material.

Photos

Highlights

  • Eldersburg, Maryland
  • 2020
  • Salsco, Inc.
  • Engine Driven, Hydraulic Feed Chippers 86 Series
  • Kohler | Briggs & Stratton
  • Fenders: 3/8” thick steel diamond plate fenders with light enclosures, flag holders and vise mount pads.
  • Available
  • 6’ 6” | Infeed Tray: 40”
  • 7’ 6” | Infeed Tray: 23”

Specifications

  • 2020
  • Salsco, Inc.
  • Engine Driven, Hydraulic Feed Chippers
  • 86 Series
  • Brush
  • Kohler | Briggs & Stratton
  • Tier IV
  • 25HP | 37HP
  • Size 6, Type P, centrifugal
  • One (1) 5-V single back belt. Cast iron pulleys with taper lock centers.
  • Hoses: JIC SAE Hose ends & fittings. 3,000 P.S.I. working & 12,000 P.S.I. burst. | Motors: Char-Lynn 17.9 displacement.
  • Sunstrand, piston type, variable speed.
  • Two (2), ST205/75D14, LR “C”, 6 ply
  • 6-bolt white spoke wheel.
  • 12 volt, CCA350, automotive type
  • Fenders: 3/8” thick steel diamond plate fenders with light enclosures, flag holders and vise mount pads.
  • 3” x 2” x 1/4” wall, rectangular steel tube, with cross beam for extra strength, continuous welds and gusseted.
  • Adjustable height
  • Infeed Opening: 6” x 12” opening at the infeed | Impeller Housing: 1/4” thick steel, impeller housing is vented to provide more air flow for chip exhaust.
  • Exhaust Chute: 360º swivel exhaust chute and exhaust flap are both quickly and easily adjusted to direct exhaust with no tools.
  • 2” ball
  • 9’ 1”
  • 6’ 6” | Infeed Tray: 40”
  • 7’ 6” | Infeed Tray: 23”
  • 6 gallon CARB approved canister
  • 4 gallon, with lockable filler cap with dip stick.
  • 3,500 lb. Torflex
  • 2,120 lbs. (Approximately)
  • Jack: 2,000 lb. capacity top-wind
  • 4-bolt, heavy duty, cast iron, greaseable & self-centering.